c***@virgilio.it
2005-12-12 14:19:00 UTC
Hi everybody.
This is the second time I try to configure my HP Multifunction Printer (PSC
1410) using hpoj on FreeBSD (the first one on 4.11, now on 6.0 - amd64).
But, for both, when I run "ptal-init setup" I receive this error message:
Probing "%/dev/usb0%/dev/ugen0"...
*** Found "PSC 1400 series" but failed to communicate with it!
*** Elapsed time for this attempt was 0 second(s).
*** Check syslog file for ptal-mlcd error messages.
*** See hpoj documentation for troubleshooting information.
and
Dec 11 10:39:33 localhost ptal-mlcd: ERROR at ExMgr.cpp:3752,
dev=<mlc:usb:probe@%/dev/usb0%/dev/ugen0>, pid=777, e=16, t=1134293973
usb_open failed!
Dec 11 10:39:33 localhost ptal-mlcd: ERROR at ExMgr.cpp:2572,
dev=<mlc:usb:probe@%/dev/usb0%/dev/ugen0>, pid=777, e=25, t=1134293973
Couldn't set up print interface!
Useless ro say that hpoj works very fine on Linux.
Is there a solution?
Thank you
emilio
This is the second time I try to configure my HP Multifunction Printer (PSC
1410) using hpoj on FreeBSD (the first one on 4.11, now on 6.0 - amd64).
But, for both, when I run "ptal-init setup" I receive this error message:
Probing "%/dev/usb0%/dev/ugen0"...
*** Found "PSC 1400 series" but failed to communicate with it!
*** Elapsed time for this attempt was 0 second(s).
*** Check syslog file for ptal-mlcd error messages.
*** See hpoj documentation for troubleshooting information.
and
Dec 11 10:39:33 localhost ptal-mlcd: ERROR at ExMgr.cpp:3752,
dev=<mlc:usb:probe@%/dev/usb0%/dev/ugen0>, pid=777, e=16, t=1134293973
usb_open failed!
Dec 11 10:39:33 localhost ptal-mlcd: ERROR at ExMgr.cpp:2572,
dev=<mlc:usb:probe@%/dev/usb0%/dev/ugen0>, pid=777, e=25, t=1134293973
Couldn't set up print interface!
Useless ro say that hpoj works very fine on Linux.
Is there a solution?
Thank you
emilio